全自動自上料攪拌車出現剩料怎么解決?

 來源:http://www.rebetdrugs.com 日期:2020-03-11 發布人:admin
  由于全自動自上料攪拌車在使用過程中有時會出現一些意外情況,如果發生這種情況,如何清洗罐內剩余的物料?
  Due to some unexpected situations in the use of Zhongke Jufeng self feeding mixer, if this happens, how to clean the remaining materials in the tank?
  1. 關掉控制室的電源開關,并掛上“請勿關閉”的警告牌。
  1. Turn off the power switch in the control room and hang the warning sign "do not turn off".
  2. 通知裝載機發生碰撞,并將裝載機斗與主機出料口對準,收料。
  2. Inform the loader of collision, align the loader bucket with the discharge port of the host machine and receive the materials.
  3.打開倉庫大門,工人穿戴防護裝備進入主機,用鏟子、風炮等工具清理未完成的混凝土。
  3. Open the gate of the warehouse, workers wear protective equipment to enter the main machine, and use shovels, air guns and other tools to clean the unfinished concrete.
  4. 打開卸料門,取出可拆下的未完成的混合混凝土。
  4. Open the discharge door and take out the removable unfinished mixed concrete.
  5. 罐內混凝土清理干凈后,工作人員檢查主機葉片是否損壞,直至工作人員確認主機底板及葉片狀態良好。工作人員離開主機后,關閉主機筒倉門。
  5. After the concrete in the tank is cleaned, the staff shall check whether the blades of the main engine are damaged until the staff confirms that the base plate and blades of the main engine are in good condition. After the staff leaves the main engine, close the main engine silo door.
  6. 在車輛供電或正常運行的情況下,工作人員應觀察斜帶、平帶的砂礫情況,配合控制室操作人員通過裝載機將砂礫清除。
  6. Under the condition of vehicle power supply or normal operation, the staff shall observe the gravel condition of inclined belt and flat belt, and cooperate with the control room operator to remove the gravel through the loader.
  7. 斜帶、平帶的廢料、砂礫清理干凈后,進行混凝土的正常生產。
  7. The normal production of concrete shall be carried out after the wastes and gravel of inclined and flat belts are cleaned.
  如果在使用全自動自上料攪拌車的過程中出現問題,無法操作時應及時將攪拌機內的混凝土取出。如果混凝土在罐內凝結,會對車輛造成腐蝕。
  If there is a problem in the use of kejufeng self feeding mixer, the concrete in the mixer shall be taken out in time when it cannot be operated. If the concrete sets in the tank, it will cause corrosion to the vehicle.