自動上料混凝土攪拌車的操作要穩重

 來源:http://www.rebetdrugs.com 日期:2021-06-07 發布人:admin
一輕:自動上料混凝土攪拌車工作時,卡車腳跟應靠近駕駛室地板,腳板應與油門踏板平行,并輕輕踩下燃油踏板。
One light: when the automatic feeding concrete mixer works, the heel of the truck should be close to the floor of the cab, the foot board should be parallel to the accelerator pedal, and the fuel pedal should be gently stepped down.
二穩:在自動上料混凝土攪拌車的運行中,節流閥應始終保持穩定。一般來說,節氣門開度在百分之七十左右。
Two stable: in the operation of automatic feeding concrete mixer, the throttle valve should always be stable. Generally speaking, the throttle opening is about 70%.
三離:自動上料混凝土攪拌車工作時,腳踏板應與制動踏板分離,平放在駕駛室地板上。切勿踩下制動踏板。攪拌車經常在路面不平的工地上工作。如果腳一直踩在制動踏板上,車身會上下移動,會導致駕駛員不小心踩下制動踏板。一般來說,我們應該通過控制油門減速來控制發動機狀況和換擋。這不僅避免了頻繁制動引起的制動系統過熱,也為自動上料混凝土攪拌車的快速提速帶來了方便。
自動上料混凝土攪拌車
Three separation: when the automatic feeding concrete mixer works, the pedal shall be separated from the brake pedal and placed on the floor of the cab. Do not depress the brake pedal. Mixer truck often works on the construction site with uneven road surface. If the foot is always on the brake pedal, the body will move up and down, which will cause the driver to accidentally press the brake pedal. Generally speaking, we should control the engine condition and shift by controlling the throttle deceleration. This not only avoids the overheat of the brake system caused by frequent braking, but also brings convenience to the rapid speed up of the automatic feeding concrete mixer.
四勤:特別是鏟挖作業時,在油門穩定的情況下,通過拉動提升和旋轉操縱桿,以一個循環的方式將鏟斗裝滿物料。提升和鏟斗轉動操縱桿的循環拉動稱為“勤勉”。這一過程非常重要,對油耗影響很大。
Fourth duty: especially in shovel digging, when the throttle is stable, the bucket is filled with materials in a cycle by pulling the lifting and rotating control lever. The cyclic pull of the lift and bucket rotation levers is called diligence. This process is very important and has a great impact on fuel consumption.
五協調:協調是提升和鏟斗操縱桿的配合。自動上料混凝土攪拌車的一般鏟挖過程是將鏟斗放在地面上,平穩地打入樁體。斗與料堆平行鏟料時,應遵循先提臂后收斗的原則。這樣可以合理避免鏟斗底部的阻力,從而充分發揮較大挖掘力。
Five coordination: coordination is the coordination of lifting and bucket control lever. The general shovel excavation process of automatic feeding concrete mixer is to place the bucket on the ground and drive into the pile body smoothly. When the bucket is parallel to the material pile, the principle of lifting the arm first and then retracting the bucket should be followed. This can reasonably avoid the resistance at the bottom of the bucket, so as to give full play to the larger excavation force.
六嚴禁:首先,嚴禁輪胎打滑。自動上料混凝土攪拌車在工作時,遇到阻力和猛烈時,經常在加油口門處出現輪胎打滑現象。這種現象通常是由于駕駛員操作不當造成的,增加了油耗,損壞了輪胎。其次,后輪嚴禁翹曲。由于自動上料混凝土攪拌車挖掘力大,司機通常會挖掘堅硬的原土和石山,如果操作不當,兩個后輪很容易升起離開地面。
Six prohibitions: first of all, it is strictly forbidden to skid the tires. When the truck is working, the tire slip often occurs at the door of the filler when it encounters resistance and violence. This phenomenon is usually caused by improper operation of the driver, which increases fuel consumption and damages the tires. Second, the rear wheels are strictly forbidden to warping. Because of the high excavation force of the automatic loading concrete mixer, drivers usually dig hard raw soil and stone mountain. If the operation is not correct, the two rear wheels are easy to rise and leave the ground.
本文來自:自動上料混凝土攪拌車更多的內容請點擊:http://www.rebetdrugs.com我們將會為您提問的問題提供一個滿意的服務,歡迎您的來電!
This article is from: automatic feeding concrete mixer. For more information, please click: http://www.rebetdrugs.com We will provide a satisfactory service for your questions, welcome your call!